Watersports
How to Wash, Dry and Store a Wetsuit Without Damaging It
12 October 2026 · 3 min read
Keep your wetsuit fresher and more flexible with simple rinsing, drying and storage habits, plus tips for checking seams and stubborn smells.
1. Start with the care label and a gentle rinse
A wetsuit spends its working life stretched, soaked and exposed to sand, salt or pool chemicals. A little attention after each session can help keep the neoprene flexible and the lining comfortable. Start by checking the manufacturer’s care instructions, especially if your suit has specialist thermal panels or unusual fastenings.
After use, rinse the suit thoroughly in cool fresh water, inside and out. Pay attention to the armpits, knee folds, cuffs and zip flap, where grit and residue can collect. A clean bath or large tub works well, but avoid dragging the suit across rough paving while you rinse it.
If you cannot rinse immediately, keep the suit out of direct sunlight and rinse it when you get home. Do not leave it bundled in a hot car or sealed in a damp kit bag for longer than necessary.
2. Wash away smells without harsh products
For a more thorough clean, use a wetsuit cleaner suitable for your suit and follow its dilution and soaking instructions. Gently move the suit through the water rather than scrubbing or twisting it. Rinse afterwards as directed by the product label.
Avoid household detergent, fabric conditioner, bleach and solvents unless the wetsuit manufacturer explicitly approves them. Washing machines and tumble dryers are also best avoided unless the care label specifically allows them: heat and mechanical action can damage neoprene, glued seams or linings.
A strong fragrance is not proof that a suit is clean. If an odour remains, check that the whole lining has been washed and dried properly before repeating an approved treatment. Do not try to solve the problem with increasingly concentrated cleaner.
3. Dry it in the shade with proper support
Let excess water drain away without wringing the suit. Hang it folded at the waist over a broad, smooth rail or a hanger designed for that method. Hanging a water-heavy wetsuit from a narrow coat hanger can put unnecessary strain on the shoulders.
Choose a shaded, well-ventilated spot, away from radiators and other direct heat. Dry the inside first, then turn the suit the right way out so both surfaces can dry completely. Keep checking thicker cuffs, ankles and thermal linings, which may stay damp after the outer fabric feels dry.
If you are drying indoors, put a tray underneath and allow air to circulate around the suit. Resist the temptation to speed things up with a hairdryer or heated towel rail.
4. Check zips, seams and small tears
Once the suit is clean, inspect the seams, knees, seat and entry opening. Look for loose stitching, lifting seam tape and small cuts in the neoprene. Do not pull a damaged area apart to investigate it; gentle inspection is enough.
Flush sandy zips with fresh water and operate them carefully rather than forcing a stuck slider. Use only a manufacturer-recommended zip care product if lubrication is needed. Keep hook-and-loop tabs fastened where practical so they cannot snag the lining.
For repairs, follow the manufacturer’s advice or consult a wetsuit repair specialist. Ordinary household glue is not a substitute for a suitable flexible repair product, and a spreading seam fault deserves attention before another session.
5. Store it well and describe it honestly when selling
Store your wetsuit completely dry in a cool, shaded place, supported without sharp folds or heavy kit piled on top. Before its next outing, check its condition and fit; cleaning cannot restore neoprene that has become brittle or permanently compressed.
If you decide to sell, photograph the size label, lining, seams and any repairs. Describe wear honestly and include the model and stated thickness where known. Selling on HobbyTrade is free, with no listing fees and no seller commission, and Buy now payments are covered by Buyer Protection.